The RiderNav R7M supports over-the-air (OTA) firmware updates to ensure optimal performance and access to the latest features.
Please note: The R7M has a USB-C port on the back, but it is for factory technician use only. We strongly advise against removing the screws to access it, as this may compromise water resistance and cause internal damage—which is not covered under warranty. For OTA updates, the R7M must be mounted on your BMW Nav Prep with the ignition on and connected to Wi-Fi.

Current Firmware Version

The latest R7M firmware version is 1.2.6. This version has been thoroughly refined and optimized by our technical team to ensure stable performance across all features. You can use your R7M with confidence.

Prerequisites for OTA Updates

Before updating, ensure the following:

• R7M is mounted on the BMW Nav Prep
• Motorcycle ignition is ON
• Stable Wi-Fi connection (mobile hotspot is acceptable)
• SD card is inserted (8GB SD card included with R7M)

How to Update

1. Check for Updates
   Go to Settings > System Update and tap Check for Updates. The system will automatically detect if a new version is available.
2. Download Update
   If a new version is found, tap Update Now to begin downloading.
3. Installation
   Once the download is complete, the R7M will automatically install and restart. Do not power off the device during this process.
4. Completion
   After installation, the system will display a success message. If the system shows "Already up to date," no further action is needed.

Important Notes

• SD Card Required: An SD card must be inserted for OTA updates (pre-installed in all R7M units).
• Power Stability: Keep the motorcycle running throughout the update to prevent interruption.
• Update Failure: If an update fails due to power loss or SD card issues, please contact customer support for assistance.